This section explains how to create and configure a Qumulo cluster on Cisco UCS servers.

Prerequisites

Before creating a cluster, ensure that:

  • All nodes are racked and cabled according to Cisco specifications
  • Out-of-band management (CIMC) is configured on each node
  • Network switches are configured for your environment
  • You have the Qumulo Core installer image

Step 1: Boot from Qumulo Core Installer

  1. Connect to each node’s CIMC interface.
  2. Launch the KVM console.
  3. Boot from the Qumulo Core USB installer or virtual media.
  4. Follow the on-screen prompts to install Qumulo Core on each node.

For instructions on creating a USB installer, see Creating a Qumulo Core USB Drive Installer.

Step 2: Create the Cluster

After installing Qumulo Core on all nodes:

  1. Note the IP address displayed on each node’s console after installation.

  2. Open a web browser and navigate to the IP address of any node.

  3. Follow the cluster creation wizard to create the cluster.

Step 3: Configure Cluster Settings

After the cluster is created:

  1. Log in to the Qumulo Web UI.

  2. Configure the following settings as needed:

    • DNS servers
    • NTP servers
    • SMB and NFS exports
    • Active Directory integration
    • LDAP configuration

For detailed configuration instructions, see the Qumulo On-Premises Administrator Guide.

Cisco Installation Documentation

For hardware installation and racking instructions, refer to the Cisco documentation: