This section explains the drive bay mapping in Quiver 1UA Gen1 nodes.
Your Quiver 1UA Gen1 chassis contains up to 12 2.5” hot-swap NVMe drives in front storage bays and one boot drive in an internal M.2 expansion slot. The following is the mapping for the drives.
Certain node types have four additional NVMe drives in internal storage bays. For more information, see Technical Specifications.
NVMe Drives in Front Storage Bays
There are 12 2.5” hot-swap NVMe drives attached with four screws to trays in front storage bays. For more information, see Installing a 2.5-Inch Storage Device to a Front Storage Bay in the ASUS documentation.
NVMe Drives in Internal Storage Bays
There are 4 2.5” hot-swap NVMe drives in snap-in, toolless trays in internal storage bays. For more information, see Installing a 2.5-Inch Storage Device to an Internal Storage Bay in the ASUS documentation.
To access the internal storage bays, you must slide the chassis out of its rack. While pulled out of the rack, the chassis must have support.
NVMe M.2 Boot Drive
The boot drive is located at the M.2 expansion slot at connector NGFF1. For more information, see Installing M.2 (NGFF) Cards in the ASUS documentation.