This section explains how to configure out-of-band management (iLO) for HPE platforms running Qumulo Core.

HPE platforms include HPE Integrated Lights-Out (iLO) for out-of-band management. iLO is HPE’s baseboard management controller (BMC); it supports the standard IPMI protocol in addition to HPE-specific web UI features (such as virtual media and the integrated remote console).

For configuration using standard ipmitool commands that apply to any BMC supporting IPMI, see Configuring the IPMI Port. The rest of this page covers HPE-specific iLO features and references.

Overview

iLO enables you to:

  • Power on, power off, and reboot servers remotely
  • Access the server console via remote console
  • Mount virtual media for OS installation
  • Monitor hardware health and sensors
  • Update firmware

Wiring the Out-of-Band Management Network

The iLO port is a dedicated 1GbE RJ-45 management port located on the rear panel of each HPE server, typically labeled “iLO” and positioned near the other network ports.

Network Requirements

  • Connect each node’s iLO port to a dedicated out-of-band management switch
  • Use a separate network (VLAN or physical) from your data network
  • Ensure the management network is accessible from your administrative workstations

Why Use a Dedicated Management Network?

Separating iLO traffic from your data network provides:

  • Reliable access: Manage nodes even when the data network is down or under heavy load
  • Security isolation: Limit access to management interfaces
  • Troubleshooting capability: Access the console during network configuration changes

IP Address Assignment

Each iLO port requires its own IP address. You can configure iLO networking via:

  • DHCP: iLO obtains an address automatically (check your DHCP server for the assigned address)
  • Static IP: Configure manually through the iLO setup screen during initial boot (press F9 during POST)

HPE iLO Documentation

For detailed instructions on configuring and using iLO, refer to the official HPE documentation:

To access iLO configuration from the BIOS System Utilities menu during POST, press F9.